Skip to main content

Vauhti Pure Pro Liquid Glide Wax 80ml

Vauhti Pure Pro Liquid Glide Wax 80ml
  • Temperature: COLD -2/-20°C ( -4/28ºF)
  • Temperature: LDR +5°C/-10°C (14/41ºF)
  • Temperature: MID +2°C/-4°C (25/36ºF)
  • Temperature: WARM +7C/-3ºC (27/45º)
  • Temperature: WET +10°C/-1°C (30/50ºF)
$70.00 - $79.99
Please select options

Details

PURE PRO liquid glide waxes are based on the ingredients used in the racing paraffin series and totally new additives, which give excellent performance and good durability to the product. PURE PRO liquid glide waxes have been developed especially for natural snow and fine-grained snow. With high-quality solvents, liquid waxes absorb effectively into the base and retain the performance of the ski base longer than hot melted paraffins. Is best when used on top of liquid base wax or traditional paraffin waxes. After the wax has dried completely brush thoroughly first with a nylon brush, then with a brass brush and again with a nylon brush.

COLD: For cold snow conditions, -2/-20°C (-4/28º F)

LDR: For wide temperature range and for variable conditions, +5°C/-10°C (14/41ºF)

MID: For damp snow, +2°C/-4°C (25/36ºF)

PRO WARM: For damp snow (26F - 44F)

WET: For wet and damp snow down to zero degrees, +10°C/-1°C(30/50ºF)

Instructions for quick glides:
• Shake the bottle well.
• Press the sponge against the ski base and squeeze the bottle lightly.
• Apply a thick layer by rubbing it back and forth on the gliding surfaces.
• Allow to dry for approximately 10 min.
• Brush thoroughly, using a nylon brush.

Tips to improve the durability and glide sensitivity:
Tip 1.  Rub in the dried gel with a natural cork or RotoCork.  Using a cork will significantly improve the product’s durability. Brush the ski base thoroughly with a nylon brush; if necessary, use a fine-bristled metal brush first.
Tip 2.  Add Vauhti Fluorocarbon Block on ski base waxed with Quick Glide. Cork and brush thoroughly, using a nylon brush. Glide will increase significantly.

Tip 3.  Rub a layer of Vauhti Fluorocarbon Block on the base, and apply a generous amount of quick glide on top of this layer, mixing to combine the two products. Let dry completely; the longer, the better. Brush heavily, using a nylon br

Reviews